Ever get your pressure washer out in the spring, fire it up, and you see water leaking from the bottom of the pump with no water pressure? This is due to seals going bad because of no lubrication, or in cold climates, water in the pump during the winter freezes and causes the cast pump to crack. STA-BIL Pressure Washer Pump Protector is quick and easy to use year-round to keep everything working properly inside your pressure washer. This product is great for protecting pressure washer pumps during storage as well as keeping pistons and seals fresh during the season for easy trouble-free startups. It is simple to use and takes seconds to protect your investment. The next generation anti-freeze and lubricant will protect your pressure washer pumps 24/7. Screw the pump protector on to the water hose inlet of the pressure washer, with the pressure washer wand disconnected. Push down on the STA-BIL Pressure Washer Pump Protector trigger and hold until you see foam come out the side the wand connects onto. Your pressure washer is now lubricated and any standing water has been pushed out.Instructions:Step One - Attach pump protector hose to the water inlet hookup.Step Two - Press down on can to dispense fluid.Step Three - Once liquid exits the pump, your pressure washer is protected.Step Four - Remove hose and store pressure washer.

 PROP 65 WARNING: This product may contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. For more information, visit www.P65Warnings.ca.gov